Firing notes 3 min read
How to Track Pottery Firing Results
A firing record connects what went into the kiln with what came out. Even if a shared studio does all your firing, a few well-chosen details can help you compare results and ask better questions when a finish changes.
Create a reference for each firing
Use the studio’s firing number if it has one, or a date plus kiln name. Put the reference on every project and test-tile record from that load. Keep bisque and glaze firings separate so that “fired Tuesday” does not become ambiguous later.
Ask for information the studio already records. If the full schedule is unavailable, note the stated cone, atmosphere and firing reference, and mark other details as unknown.
Record the programme and the evidence
When available, record the target cone, peak temperature with units, ramp rates, holds and cooling programme. Keep the actual firing log or operator’s notes alongside the intended programme, particularly if there was an interruption.
A controller temperature is not the whole story. Witness cones indicate the combined effect of time and temperature, often called heatwork. Record their location and appearance after firing; cones at different positions can help reveal variation within a load. See Orton’s explanation of pyrometric cones. Cone 06 and cone 6 are different firing ranges, so preserve leading zeros in your notes.
Keep a compact firing checklist
- Firing reference, date, kiln and operator or studio.
- Bisque or glaze firing, atmosphere and target cone.
- Programme reference, units, holds and cooling details if supplied.
- Shelf position and witness-cone observations if available.
- Piece or tile identifiers, clay bodies and glaze versions.
- Application method and any departures from the usual process.
- Photos, surface observations and one proposed follow-up test.
Describe the result before explaining it
Write “small pits inside bowl, outer wall smooth” before deciding why the pits appeared. Photograph the whole piece and a close-up under consistent lighting. Record texture, colour, gloss, running and visible defects separately.
An example note might read: “Tile T12, middle shelf, glaze v2, two brushed coats: darker in grooves, small pinholes at lower edge.” This gives you a result to investigate without pretending a single observation proves its cause.
Compare like with like
Place records from the same clay and glaze version side by side. Check application differences before attributing everything to the kiln. Discuss any firing adjustments with the kiln operator and change one variable at a time when practical.
Keep repeated successes too. Several consistent tests are more useful than one attractive tile. Your journal can guide the next test, but it does not replace the kiln manufacturer’s instructions or the studio’s operating procedures.